Vertical-joint concrete PSB K40
Product description
Fescon Vertical-joint Concrete is a non-sag special concrete used in the vertical grouting of concrete elements. Maximum grain size 3.0 mm.
- strength class C 30/37
- good adhesion
- pumpable
- non-sag
Applications
- grouting of elements
- industrial door frame casting
- casting applications with difficult mould work
The product is suitable for use on sites with a Nordic Swan Ecolabel.
Vinkki! Vieritä taulukkoa sivuttain
6416841330031
|
VERTICAL-JOINT CONCRETE PSB K 40
|
33003
|
1000 kg
|
Refer to the bag for how much water the concrete requires. Add the dry material to the water and mix with a concrete mixer for around ten minutes. With a power mixer, around one to three minutes of mixing is sufficient. Let the mass stand for a while and mix it again for a short while. Find the correct consistency at this stage by gradually adding the rest of the water. We do not recommend adding all of the water right at the start. If you are unable to use the concrete immediately after mixing, we recommend mixing it again before casting. The finished concrete remains workable for around one hour.
The joint or area being concreted over must be undamaged, clean, and damp enough to be darker in colour. If necessary, remove the weak-strength cement paste layer. Best adhesion can be achieved to a rough base. The joint width must be sufficient (at least 15 mm) so that the casting mass fills the joint entirely.
Pump the mass to the casting location using either a screw or piston pump. When adjusting the pump output, take the joint thickness and prevailing conditions into consideration. The concrete has the correct amount of water when the pumped mass does not flow out of the joint. Level the joint that was cast with a steel trowel. Cast a joint that is open to both sides by blocking one side of the joint with a stopper board. Remove the board a while after pumping, once the concrete has hardened somewhat. Finally, level the joint surface on the side of the board with a trowel. Vertical grouting concrete is not vibrated. The lowest working temperature is +5°C.
The joints are wetted for 2 to 3 days after casting.
Waste handling
Hardened product and empty, dry packages can be delivered to a landfill. A liquid product must be delivered to a hazardous waste reception point.
Water requirement |
3.5-4.1 l/25 kg |
Finished compound |
13 - 14 l / 25 kg bag |
Type |
powder |
Colour |
grey |
Maximum grain size |
3 mm |
Package size |
1000 kg |
Storage |
storage time in a dry location approx. 1 year |
Lowest usage temperature |
+ 5°C |
Workability time |
1 h |
Strength class |
C 30/37 |
Compressive strength |
K 40 |
Exposure class |
C 30/37 for concrete 50 (100) year design service life XC3(XC3) and XF3(XF3) |
Chloride content |
0.01 % |
The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.