Cement plaster S 30
Product description
Fescon Cement Plaster S 30 is a cement-based dry mortar. The maximum grain size is 3.0 mm.
The strength class of the product increases. The strength class is C 30/37 from the date of manufacture 1.1.2022.
- Easy to use
- Rubbable
- Good workability characteristics
- Frost-resistant
- Good grip on the base
Applications
- Repairs of cast defects in concrete structures
- Thin-cast floor surfaces
- Jointing of prefabricated concrete elements
- Plastering of foundation walls made from blocks, e.g. top and bottom joints of wall elements
The product is suitable for use on sites with a Nordic Swan Ecolabel.
Vinkki! Vieritä taulukkoa sivuttain
6416841530202
|
CEMENT PLASTER S 30
|
53020
|
25 kg
|
6416841330208
|
CEMENT PLASTER S 30
|
33020
|
1000 kg
|
Base
Clean the base of loose dust and dirt. Remove cement paste from concrete surfaces. Wet the dry base until it darkens. The best time to wet the surface is the previous night.
Mixing
Refer to the bag for how much water the plaster requires. Add the dry material to the water and mix with a concrete mixer for around five minutes. With a power mixer or a drill paddle, around one to two minutes of mixing is sufficient. Allow the plaster to stand for around ten minutes and mix it again for a short while. Find the correct consistency at this stage by gradually adding the rest of the water. We do not recommend adding all of the water right at the start. The finished plaster remains workable for around two hours.
Casting
Apply the plaster to the casting location that is damp enough to be darker in colour, and compact carefully. In floor surface casting, the old base can be reinforced with plastic dispersion spread on a dry surface.
Plastering
In plastering, the plaster is slammed into a surface that is damp enough to be darker in colour. Recommended layer thickness is around 20 mm.
After treatment
You must care for the fresh casting and plastering surface by spraying with water and/or protecting it with a plastic film. The need for aftercare depends on the conditions. It should continue for at least one to three days.
Waste handling
Storage and handling of waste. See the separate storage and disposal instructions https://www.fescon.fi/en/material-bank
Material usage |
20 kg/m2 with a 10 mm layer thickness |
Water requirement |
2.5-3.3 l/25 kg |
Finished compound |
12 - 13 l / 25 kg bag |
Type |
powder |
Colour |
grey |
Maximum grain size |
3 mm (the shape of natural stones may vary) |
Storage |
storage time in a dry location approx. 1 year |
Lowest usage temperature |
+ 5°C |
Workability time |
2 h |
Strength class |
C 30/37 The strength class of the product increases. The strength class is C 30/37 from the date of manufacture 1.1.2022. |
Fire class |
A1 |
Exposure class |
XF 1, XC 4, XD 2 (50 years) |
Frost resistance |
Frost-resistant |
The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.