Silicone-resin primer MC
Product description
The Silicone-resin Primer is a primer that guarantees good adhesion, more even absorption and better grip for concrete, board and plaster surfaces, and paint surfaces in a good condition.
- Regulates absorption
- Improves adhesion and grip
- Alkali-resistant
- Easy to work with
- White or tinted
- Thin with 5-20% water depending on the base
Applications
- Concrete surfaces
- All plastered surfaces
- Board surfaces
- Firm old coatings
- For outdoor and indoor use
Vinkki! Vieritä taulukkoa sivuttain
6416841760500
|
Silicone-resin primer MC
|
86050
|
15 kg
|
|
Silicone-resin primer MC
|
50305
|
15 kg
|
|
SILIKONIHARTSIPOHJUSTE MC sävytys HR 2 muut sävyt
|
50306
|
15 kg
|
Remove impurities from the surfaces, roughen and clean old coated surfaces, and entirely remove weak, old coatings. Do not work with the product in direct sunlight, in high winds, or when the air humidity is high (>80%). The fresh primer must be protected from too rapid drying, frost and rain during the work and until it has dried entirely. Apply the primer to a dry base using a brush, sprayer or a roller. Ensure that the base is durable, dry and clean. We recommend tinting the primer to match the coating. Thin with 5-20% water depending on the base. Thinning affects the opacity of the product’s tint. Depending on air humidity and temperature, further treatment can be done no earlier than after 12 hours (20 °C/65% relative humidity).
Cleaning of tools
Clean with water immediately after use.
Storage
Store in a dry and cool storage. Do not allow to freeze. The maximum allowed storage temperature +25°C must not be exceeded. When the storage temperature is lower, the primer must be placed into an intermediate storage at a temperature of around +20°C before working.
Waste handling
Hardened product and empty, dry packages can be delivered to a landfill. A liquid product must be delivered to a hazardous waste reception point.
Material usage |
approx. 200 g/m 2 depending on the base |
Binder |
plastic dispersion |
Package size |
15 kg |
Storage |
Store in a dry and cool storage. Do not allow to freeze. The maximum allowed storage temperature +25°C must not be exceeded. When the storage temperature is lower, the primer must be placed into an intermediate storage at a temperature of around +20°C before working. |
Density |
1.48 g/cm3 |
Usage temperature |
The temperature of the base and air must be < + 5°C |
Thinner |
water |
Tintability |
Can be tinted |
VOC content |
<1 g/l EU limit value for the product cat. A/g 30 g/l) (2010) |
The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.