2-K Primer
Product description
Fescon 2-K Primer is a two-component, solvent-free epoxy primer that withstands heavy mechanical loads, lye, weak acids, mineral oils, and other chemicals.
- improves chemical resistance
- binds dust
- increases wear resistance
- A+B components as ready-to-mix portions
- spreading with a rubber, plastic or metal trowel and airless spray
Applications
- preparation of balcony and stone surfaces
Vinkki! Vieritä taulukkoa sivuttain
6416841762603
|
2-K Primer 10KG
|
76260
|
10 kg
|
Old concrete surfaces
Clean the old concrete surfaces of loose dust, dirt, grease and oil stains. Remove old, flaking coatings and paints, for example by sand blasting, grinding or milling. If the concrete surface is damaged, remove concrete until you reach healthy concrete. Open any cracks with an angle grinder. Patch any resulting cavities and open cracks and correct the grading of balconies using Fescon Repairing Plaster, grain size 3.0 mm or 1.2 mm, or Overlaying Plaster, depending on the layer thickness.
New concrete surfaces
Remove the cement paste layer from new concrete surfaces and vacuum the grinding dust carefully. If necessary, patch up the cavities and holes and overlay the surface as above. The concrete must have a strength of over 20 MPa and must be at least four weeks old before priming.
The treated surface must be dry, clean and structurally sound. The temperature must be between + 5°C and + 25°C and the relative humidity below 80%. The moisture content of the base must be below 90% relative humidity. Measure with a surface moisture meter. Mix carefully with a power mixer before use (less than 400 RPM). Use a mixing container; do not spread from the delivery package. The mixed product must be used within 30 minutes.
Spread the well-mixed Fescon 2-K Primer with a trowel or an airless sprayer onto the base so that the base becomes saturated. Prime very porous bases twice. The primer must be applied in such a manner that the surface film is continuous and there are no pores in the surface. The primed areas must be coated within 6-24 hours; if necessary, the primer can be sanded while fresh with clean, oven-dried quartz sand. In humid conditions, you must ensure sufficient ventilation. Wash tools with a suitable solvent immediately after use, for example with Fescon Thinner.
Waste handling
Hardened product and empty, dry packages can be delivered to a landfill. A liquid product must be delivered to a hazardous waste reception point.
Material usage |
200-400 g (single treatment) |
Type |
liquid |
Colour |
colourless |
Package size |
component A 2.5 l container, component B 5.0 l container |
Storage |
stored at a temperature of + 5°C – + 20°C in dry conditions. Shelf life 12 months in the original, unopened container |
Density |
1.0 kg/l |
Lowest usage temperature |
+ 5°C |
Drying time |
withstands pedestrian traffic after 24 h (+23°C RH 50%). Final drying 7 days |
Pull-out strength |
> 1.5 MPa |
Solid content |
component A: 51% by weight component B: 15% by weight |
Thinner |
Fescon thinner |
Method of application |
trowel or airless sprayer |
The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.