Mortar for tongue-and-groove blocks PHL
Product description
Fescon Mortar for Tongue-and-groove Blocks is a dry mortar for the thin-jointing of lightweight aggregate blocks. The maximum grain size is 1.2 mm. Fescon Stone Adhesive is used for the thin-jointing of sand-lime bricks.
- easy to use
- good workability characteristics
- frost-resistant
- low water absorption capacity
Applications
- for thin-joint masonry both indoors and outdoors
The product is suitable for use on sites with a Nordic Swan Ecolabel.
Vinkki! Vieritä taulukkoa sivuttain
6416841530196
|
MORTAR FOR TONGUE-AND-GROOVE BLOCKS PHL
|
53019
|
25 kg
|
6416841330161
|
MORTAR FOR TONGUE-AND-GROOVE BLOCKS PHL
|
33016
|
500 kg
|
6416841330192
|
MORTAR FOR TONGUE-AND-GROOVE BLOCKS PHL
|
33019
|
1000 kg
|
Refer to the bag for how much water the plaster requires. Add the dry material to the water and mix with a concrete mixer for around ten minutes. With a power mixer or a drill paddle, around two to three minutes of mixing is sufficient. Allow the plaster to stand for around ten minutes and mix it again for a short while. Find the correct consistency at this stage by gradually adding the rest of the water. We do not recommend adding all of the water right at the start. The finished plaster remains workable for around three hours.
The lowest working temperature is +5°C. The temperature of the stones must be above 0°C. Follow the instructions of the designers and official regulations in masonry work. National Building Code of Finland B5 and National Building Code of Finland B8, and RYL 2000 instructions.
Waste handling
Hardened product and empty, dry packages can be delivered to a landfill. A liquid product must be delivered to a hazardous waste reception point.
Material usage |
0.5 kg/H-75; 1.5 kg/UH-100…UH-150; 2.5 kg/RUH-200…RUH-380 |
Water requirement |
3.5 l / 25 kg bag |
Finished compound |
13 - 14 l / 25 kg bag |
Type |
powder |
Colour |
grey |
Maximum grain size |
1.2 mm |
Package size |
25 kg, 500 kg and 1000 kg |
Storage |
storage time in a dry location approx. 1 year |
Lowest usage temperature |
+ 5°C |
Workability time |
3 h |
Strength class |
M 10 |
Nominal shear resistance |
> 0.16 N/mm2 (avg) |
Fire class |
A1 |
Heat conductivity |
0.83 W/mK |
Frost resistance |
Yes |
Water vapour permeability |
µ 15/35 |
The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.