Socle and adjusting plaster SOL

Product description

Fescon Socle and Adjusting Plaster SOL is a cement-based, polymer-modified fibre-reinforced plaster that contains additives improving its weather resistance and reducing capillary water absorption. The maximum grain size is 0.6 mm.


  • easy to use
  • rubbable
  • good workability characteristics
  • good grip on the base
  • spray-applied
  • M1 approval


  • adjustment of concrete, brick and block surfaces both indoors and outdoors
  • adjusting and levelling of concrete and block foundation walls
The product is suitable for use on sites with a Nordic Swan Ecolabel.

Vinkki! Vieritä taulukkoa sivuttain
EAN code Product name Product number Package size
6416841530066 Socle and adjusting plaster SOL 53006 25 kg


Refer to the bag for how much water the plaster requires. Add the dry material to the water and mix with a concrete mixer for around ten minutes. With a power mixer or a drill paddle, around one to two minutes of mixing is sufficient. Allow the plaster to stand for around ten minutes and mix it again for a short while. Find the correct consistency at this stage by gradually adding the rest of the water. We do not recommend adding all of the water right at the start. The finished plaster remains workable for around two hours.

Clean the base of loose dust and dirt. Remove cement paste from concrete surfaces.
Wet the dry base until it darkens. The best time to wet the surface is the previous night.

Spread the plaster with a plaster sprayer or a steel trowel onto a base damp enough to be darker in colour. The recommended thickness of a single plaster layer on walls is no more than 5 mm and, on foundation walls, 10 mm. The levelled walls can be coated with, for example, Fescon Facade, Silicone resin coating MC, Piirto-, Fescosan or painted with Fescon Stone Colour S. Thin-layer-plastered foundation walls can be left uncoated. Avoid plastering in high winds or in direct sunlight. The lowest working temperature is +5°C.

In very damp conditions, keep the fresh plastered surface damp by spraying it with water or by protecting the surface with a plastic film. The need for aftercare depends on the conditions. It should continue for at least one to two days.

Waste handling

Waste is collected mechanically and disposed of in accordance with local instructions. Hardened waste is handled as construction waste.

Technical information

Material usage

5-10 kg/m² (with a 2-5 mm layer thickness)

Water requirement 4.5-5.5 l/25 kg
Finished compound 13 - 14 l / 25 kg
Type powder
Colour grey
Maximum grain size

0.6 mm

Package size 25 kg

in a dry location approx. 1 year

Lowest usage temperature

+ 5°C

Workability time 2 h
Compressive strength

approx. 10 MPa

Pull-out strength > 1.5 MPa
Fire class A1

The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.


Enter amount