Lime-cement plaster KS 10/90
Product description
The Fescon Tile Grout KS 10/90/500 is an air entrained, lime cement based dry mortar. The maximum grain size is 3.0 mm. The KS 10/90/500 mortar is used as an adhesion plaster.
- just add water
- extremely weather-resistant
- pumpable
- breathable
Applications
- burnt brick
- sturdy lime-cement plastering
- Kahi-brick
- insulation plastering
- concrete surfaces
- block surfaces
The product is suitable for use on sites with a Nordic Swan Ecolabel.
Vinkki! Vieritä taulukkoa sivuttain
6416841530554
|
Lime-cement plaster KS 10/90 3 mm
|
53055
|
25 kg
|
6416841330550
|
Lime-cement plaster KS 10/90 3 mm
|
33055
|
1000 kg
|
Refer to the bag for how much water the plaster requires. Add the dry material to the water and mix with a concrete mixer for around ten minutes. With a power mixer or a drill paddle, around one to three minutes of mixing is sufficient. Allow the plaster to stand for around ten minutes and mix it again for a short while. Find the correct consistency at this stage by gradually adding the rest of the water. We do not recommend adding all of the water right at the start. Every batch must be mixed in the same way. The finished plaster remains workable for around two to three hours.
The base and the plaster surface to be repaired must be clean and undamaged. Remove salt, dust, rust and compact cement paste, for example by water sand blasting. If necessary, wet a dry surface while retaining the absorption capacity of the base. Select the patching plaster grade according to the strength of the base. In deep patching, we recommend using coarse, so-called manual plasters. Allow the patches to harden at least for a couple of days before plastering the entire surface.
Slam or spray the adhesive plaster tightly to the base so that it fills 90-95% of the base. Plaster usage is 3-6 kg/m2. The adhesive plaster must be allowed to harden for at least one day before filling. The lowest usage temperature is + 5°C.
If necessary, you must remember the aftercare of the adhesive plaster, for example by spraying it with water.
Waste handling
Hardened product and empty, dry packages can be delivered to a landfill. A liquid product must be delivered to a hazardous waste reception point.
Material usage |
3-6 kg/m² (adhesion) |
Water requirement |
3.5-4.5 l/25 kg |
Finished compound |
13 - 14 l / 25 kg |
Maximum grain size |
3 mm |
Package size |
25 kg and 1000 kg |
Storage |
storage time in a dry location approx. 1 year |
Density |
1.84 kg/dm³ |
Workability time |
2-3 h |
Fire class |
A1 |
Air content |
approx. 16% |
Frost resistance |
flexural and compressive strength do not decrease after 200 melt-freeze cycles |
Flow/plasticity |
Hägermann 170 mm |
Water retention capacity |
80- 90% |
The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.