Lime-cement plaster KS 35/65

Product description

The Fescon Tile Grout KS 35/65/500 is an air entrained, lime cement based dry mortar. The maximum grain size is 3.0 mm. The KS 35/65/500 mortar is used as an adhesion or filling plaster.

 

  • just add water
  • extremely weather-resistant
  • pumpable
  • breathable

Applications

  • burnt brick
  • sturdy lime-cement plastering
  • Kahi-brick
  • insulation plastering
Vinkki! Vieritä taulukkoa sivuttain
EAN code Product name Product number Package size
6416841530561 LIME-CEMENT PLASTER KS 35/65 53056 25 kg
6416841330567 LIME-CEMENT PLASTER KS 35/65 33056 1000 kg

Instructions

Refer to the bag for how much water the plaster requires. Add the dry material to the water and mix with a concrete mixer for around ten minutes. With a power mixer or a drill paddle, around one to three minutes of mixing is sufficient. Allow the plaster to stand for around ten minutes and mix it again for a short while. Find the correct consistency at this stage by gradually adding the rest of the water. We do not recommend adding all of the water right at the start. Every batch must be mixed in the same way. The finished plaster remains workable for around two to three hours. Lowest usage temperature + 5°C.

The brick surface and the plaster surface to be repaired must be clean and undamaged. Remove salt, dust, rust and compact cement paste, for example by water sand blasting. If necessary, wet a dry surface while retaining the absorption capacity of the base. Select the patching plaster grade according to the strength of the base. In deep patching, we recommend using coarse, so-called manual plasters. Allow the patches to harden at least for a couple of days before plastering the entire surface.

Slam or spray the adhesive plaster tightly to the base so that it fills 90-95% of the base. The adhesive plaster must be allowed to harden for at least one day before filling. Apply the filling plaster with a plaster trowel or a pump. A suitable thickness for one layer of filler is around 15 mm. If the layer thickness exceeds 20 mm, the filler must be applied in several layers so that the previous layer has had time to dry for one to two days before the next layer is applied. In dry conditions, the base must be dampened. Screed the filler plaster with a board. You can also carefully float the surface with a wooden tool to level the surface.

If necessary, you must remember the aftercare of the adhesive plaster, for example by spraying it with water.

Waste handling

Hardened product and empty, dry packages can be delivered to a landfill. A liquid product must be delivered to a hazardous waste reception point.

Technical information

Material usage

3-6 kg/m² (adhesion)
approx. 30 kg/m² (fill to approx. 15 mm layer)

Water requirement 3.5-4.5 l/25 kg
Finished compound 13 - 14 l / 25 kg
Maximum grain size

3 mm

Package size 25 kg and 1000 kg
Storage

storage time in a dry location approx. 1 year

Workability time 2-3 h
Fire class A1
Air content approx. 16%
Frost resistance flexural and compressive strength do not decrease after 200 melt-freeze cycles
Flow/plasticity

Hägermann 170 mm

Water retention capacity 80- 90%

References

Other links

The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.

Products

Enter amount

units
Add