Lime-cement plaster KS 65/35

Product description

The Fescon Tile Grout KS 65/35/600 is an air entrained, lime cement based dry mortar. The maximum grain size is 1.2 or 0.6 mm. The KS 65/35/600 mortar is used as a finishing plaster.


  • pumpable
  • good weather resistance
  • rubbable
  • breathable


  • lime-cement plastering
  • brick surfaces
The product is suitable for use on sites with a Nordic Swan Ecolabel.

Vinkki! Vieritä taulukkoa sivuttain
EAN code Product name Product number Package size
6416841570611 Lime-cement plaster KS 65/35 0,6 mm 57061 25 kg
6416841560612 Lime-cement plaster KS 65/35 1,2 mm 56061 25 kg
6416841360618 Lime-cement plaster KS 65/35 1,2 mm 36061 1000 kg


Refer to the bag for how much water the plaster requires. Add the dry material to the water and mix with a concrete mixer for around ten minutes. With a power mixer or a drill paddle, around one to three minutes of mixing is sufficient. Allow the plaster to stand for around ten minutes and mix it again for a short while. Find the correct consistency at this stage by gradually adding the rest of the water. We do not recommend adding all of the water right at the start. Every batch must be mixed in the same way. The finished plaster remains workable for around two to three hours. Lowest usage temperature + 5°C.

The filler must have properly hardened and be at least two or three days old before the finishing plaster is applied. The base must also not have been floated smooth. If necessary, wet the base before applying the finishing plaster.

Finishing plaster is normally applied with a plastering pump, but manual slamming is also possible. The total layer thickness will be 3-5 mm.You can create different surface structures by varying the plaster plasticity, nozzle size, air volume and spraying distance. The suitable spraying distance for a plaster sprayer is around 1 metre, and around 0.6 metres for a funnel top sprayer. Spraying from too close to the surface will easily result in shiny patches. The finishing plaster’s surface is either left as is or floated.Adhesion and fill plastering

A finishing plastering should be given aftercare for at least three days. The aftercare must be begun as early as possible so that plastic cracks in the fresh plaster can be prevented.

Waste handling

Storage and handling of waste. See the separate storage and disposal instructions

Technical information

Material usage

6-10 kg/m²

Water requirement 4.5-5.5 l/25 kg
Finished compound 13 - 14 l / 25 kg
Maximum grain size

1.2 mm or 0.6 mm

Package size 25 kg and 1000 kg

storage time in a dry location approx. 1 year

Workability time 2-3 h
Fire class A1
Air content approx. 12%

Hägermann 160 mm

Water retention capacity 80- 90%

The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.


Enter amount