Lightweight lime-cement plaster KEV KS 35/65
Product description
Fescon Lightweight Lime-cement Plaster KEV is an adhesion and filling plaster with lime-cement binder containing mineral lightweight filler materials.
- good workability
- good weather resistance
- pumpable or manually applied
Applications
- brick, block and lightweight concrete surfaces
- facade and interior wall plastering
- thick fills, replacement for plaster of Paris
- improving sound insulation
- patching and adjustments
The product is suitable for use on sites with a Nordic Swan Ecolabel.
Vinkki! Vieritä taulukkoa sivuttain
6416841253118
|
Lightweight lime-cement plaster KEV KS 35/65
|
25311
|
25 kg
|
Refer to the bag for how much water the plaster requires. Add the dry material to the water and mix with a concrete mixer for around three to five minutes. With a power mixer or a drill paddle, around one to three minutes of mixing is sufficient. Allow the plaster to stand for around ten minutes and mix it again for a short while. Find the correct consistency at this stage by gradually adding the rest of the water. We do not recommend adding all of the water right at the start. Every batch must be mixed in the same way. The finished plaster remains workable for around two to three hours.
The brick surface and the plaster surface to be repaired must be clean and undamaged. If necessary, wet a dry surface while retaining the absorption capacity of the base. Use the same lightweight lime-cement plaster for patching. The patches must be allowed to dry sufficiently before the entire surface is plastered. Adhesion plaster is not required.
Apply the filling plaster with a plaster trowel or a pump. A suitable thickness of one filling plaster layer is 10-60 mm in overlevelling and 10-100 mm in patching. If the required layer thickness is greater, do the work in several layers. In dry conditions, the base must be dampened. Screed the filler plaster with a board. You can also carefully float the surface with a wooden tool to level the surface.
You can use plastering mesh to reduce the cracking risk caused by the drying of the plaster and cracks in the base. You should in particular use a mesh at the joints of different materials, as reinforcement near openings and corners, and when plastering Siporex surfaces.
A fill plastering should be given aftercare for around three days. The aftercare must be begun as early as possible so that plastic cracks in the fresh plaster can be prevented.
Waste handling
Hardened product and empty, dry packages can be delivered to a landfill. A liquid product must be delivered to a hazardous waste reception point.
Material usage |
approx. 1.2 kg/m² with a 1 mm layer thickness |
Water requirement |
4-5 l/25 kg |
Finished compound |
13 - 14 l / 25 kg |
Maximum grain size |
1.2 mm |
Package size |
25 kg |
Storage |
storage time in a dry location approx. 1 year |
Density |
approx. 1350 kg/m3 |
Workability time |
2-3 h |
Compressive strength |
approx. 5 MPa |
Adhesion strength |
> 0.5 MPa |
Flexural bond strength |
0.5 MPa |
Fire class |
A1 |
Air content |
approx. 10-14% |
The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.