Adhesive plaster TL

Product description

The Fescon Adhesive Plaster is a cement-based, polymer-modified, cement-based dry mortar with additives. The maximum grain size is 0.6 mm.


  • Easy to use
  • Good adhesion
  • Application by brush or spray
  • Chloride-free
  • Slow carbonation
  • Protects steel from rusting


  • Adhesive plaster for repair plasters used in concrete structure repair work
  • Corrosion protection of reinforcement bars uncovered during the repair of concrete structures
The product is suitable for use on sites with a Nordic Swan Ecolabel.

Vinkki! Vieritä taulukkoa sivuttain
EAN code Product name Product number Package size
6416841450265 Adhesive plaster TL 45026 25 kg



Clean the adhesion base of loose dust and dirt. Before applying the plaster, wet the area so that is damp enough to be darker in colour.


Refer to the package for how much water the plaster requires. Add the dry material to the water and mix with a concrete mixer for around ten minutes. With a power mixer or a drill paddle, around one to two minutes of mixing is sufficient. Allow the plaster to stand for around ten minutes and mix it again for a short while. Find the correct consistency at this stage by gradually adding the rest of the water. We do not recommend adding all of the water right at the start. The finished plaster remains workable for around two hours.

Spreading the plaster

The plaster is spread onto a base that is damp enough to be darker in colour with a sprayer, roller or brush. Adhesion-wise, the best method is strong brushing. Spread repairing plaster over the adhesion plaster that is still wet or has dried completely.

Pretreatment of reinforcements

Remove damaged concrete from around the damaged reinforcement, for example by chiselling or water sand blasting. Make the holes large enough and shape them so that any rusted reinforcements can be cleaned or, if necessary, replaced with new ones. Choose the cleaning method appropriate for the situation (e.g. steel brushing, sand blasting or water sand blasting) so that a Sa 2 or St 2 level of cleanliness can be achieved. Finally, clean the base of loose dust and dirt, for example by pressure washing.

Protecting the reinforcements

Apply one or two layers of Adhesive Plaster to the cleaned reinforcing bars. Apply the first layer as soon as possible after the reinforcements were cleaned. The thickness of one layer is around 1 mm. You can apply a new layer 2-3 hours after the plaster has hardened enough to feel dry to the touch. The lowest working temperature (air and the treated surfaces) is +5°C. Once the plaster has hardened enough to feel dry to the touch, fill in the repaired place with Fescon Repairing Plaster or Non-sag Filler.

Waste handling

Storage and handling of waste. See the separate storage and disposal instructions

Technical information

Material usage

1 mm layer 0.1-0.2 kg per lineal metre in steel protection, depending on its size
1.5-2.0 kg/m² as adhesive plaster

Water requirement approx. 6 l/25 kg
Finished compound 12 - 13 l / 25 kg
Type powder
Colour grey
Package size 25 kg

storage time in a dry location approx. 1 year

Lowest usage temperature

+ 5°C

Workability time 2 h
Adhesion strength

> 1.5 MPa

Fire class A2

The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.


Enter amount