Sanitary silicone
Product description
Fescon Sanitary Silicone is a one-component silicone mass for expansion joints and sealing. The mass is suitable for use in wet areas, and the silicone tints match those of the Fescon Tile Seaming Plaster.
- Easy to use
- Contains an anti-mould additive
- Cannot be overcoated
- Not suitable for aquariums or swimming pools
- Several colours
The product is listed in the portal for building products that can be used in Nordic Swan Ecolabelled buildings.
Vinkki! Vieritä taulukkoa sivuttain
6416841259134
|
Sanitary silicone colorless
|
25913
|
1 pcs
|
6416841259165
|
Sanitary silicone white
|
25916
|
1 pcs
|
6416841260109
|
Sanitary silicone marble white
|
26010
|
1 pcs
|
6416841259202
|
Sanitary silicone gray
|
25920
|
1 pcs
|
6416841260055
|
Sanitary silicone light grey
|
26005
|
1 pcs
|
6416841259219
|
Sanitary silicone dark gray
|
25921
|
1 pcs
|
6416841260017
|
Sanitary silicone light beige
|
26001
|
1 pcs
|
6416841260123
|
Sanitary silicone beige
|
26012
|
1 pcs
|
6416841260130
|
Sanitary silicone black
|
26013
|
1 pcs
|
6416841260116
|
Sanitary silicone black gray
|
26011
|
1 pcs
|
Work instructions
- Unscrew the plug of the extrusion tip and cut open the cone at the end. Screw the extrusion tip into place and cut it down to the desired size.
- The grouting base must be dry and free of dust and grease.
- Squeeze the silicone mass into the seam and immediately smooth it out with a joint knife or a finger moistened with clean water.
- When redoing the seams, the old silicone must be removed; so must spots of mould and other substances reducing adhesion.
Service instructions
- In wet areas, the silicone seams must be checked regularly and replaced if necessary, and at least every five years.
- The product is not suitable for overpainting or for use in aquariums or swimming pools.
Waste handling
Storage and handling of waste. See the separate storage and disposal instructions https://www.fescon.fi/en/material-bank
Material usage |
approx 12 m of 5*5 seam / cartridge |
Binder |
silicone polymer |
Package size |
300 ml cartridge |
Storage |
in a warm location below +25 °C, see package for the best before date |
Density |
approx. 1.0 - 1.4 kg / dm2 |
Lowest usage temperature |
recommended +18°..+22°C (however between +5° - + 35 °C) |
Shrinkage |
< 5% |
Heat resistance |
-40°C..+150°C |
The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.