Bedding plaster VF

Product description

Fescon Bedding Plaster VF is a cement-based bedding plaster for interior walls.



  • Wall and ceiling surfaces in both dry and wet areas
  • Suitable for block, lightweight concrete, brick and concrete surfaces
  • On old paint surfaces, the Fescon Tile Adhesive Plaster is used as the adhesive plaster
  • The levelling compound cannot be used for floor levelling, soft lime cement plastering or surfaces levelled with a water-soluble compound
  • Bedding plaster for fastening the reinforcing membrane with waterproof premixed adhesive
The product is suitable for use on sites with a Nordic Swan Ecolabel.

Vinkki! Vieritä taulukkoa sivuttain
EAN code Product name Product number Package size
6416841201041 BEDDING PLASTER VF 20104 20 kg



Before applying the levelling compound, wet any dry and water-absorbent bases.


Refer to the package for how much water the levelling compound requires. Add the dry material to the water and mix with a drill paddle for around one to two minutes. Let the levelling compound stand for around ten minutes and mix it again for a short while. The finished levelling compound remains workable for around four hours.

Work instructions

Spread the levelling compound on the base either with a levelling spray or a steel trowel. You can recover and reuse any extra compound. When applying several layers of the levelling compound, allow the previous layer to harden completely before applying the next layer. Depending on the conditions, the hardening will take one to two days. If necessary, the dried surface is ground after the application of each layer of levelling compound.

The levelled surface can be papered, tiled or painted with a cement-resistant paint. You can also float the surface with a moist sponge. Wait until the levelling compound has hardened a little before floating.

After treatment

In dry conditions, wet the levelled surface with a water spray.

Waste handling

Storage and handling of waste. See the separate storage and disposal instructions

Technical information

Material usage

1 mm layer approx. 1.2 kg/m²

Water requirement 5.6 - 6.4 l / 20kg
Type powder
Binder cement
Colour grey
Maximum grain size

0.6 mm

Package size 20 kg

storage time in a dry location approx. 1 year

Layer thickness

1 - 5 mm

Lowest usage temperature

+ 10°C

Workability time 4 h
Coatability painting, papering and tiling
Hardening time

approx. 1 day at + 20°C, approx. 3 days at + 10°C
drying time depends on layer thickness and the humidity in the drying area

Compressive strength

28 days approx. 10 MPa

Adhesion strength

> 0.5 MPa (for a concrete surface)

Fire class A1
Exposure class RL 01 - RL 05

The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.


Enter amount