Brick bedding plaster TTF
Product description
Fescon Brick Bedding Plaster TTF is a cement-based levelling compound for interior walls.
Applications
- wall and ceiling surfaces in both dry and wet areas
- suitable for block, brick, lightweight concrete, brick plaster and plastered surfaces
- on old paint surfaces, the Fescon Tile Adhesive Plaster is used as the adhesive plaster
- the levelling compound cannot be used for floor levelling, soft lime cement plastering or surfaces levelled with a water-soluble compound
- when fastening a reinforcing membrane with premixed adhesive, you must use Fescon levelling compound VF, VHF or WTT
The product is suitable for use on sites with a Nordic Swan Ecolabel.
Vinkki! Vieritä taulukkoa sivuttain
6416841201034
|
BRICK BEDDING PLASTER TTF
|
20103
|
20 kg
|
Refer to the package for how much water the levelling compound requires. Add the dry material to the water and mix with a drill paddle for around one to two minutes. Let the levelling compound stand for around ten minutes and mix it again for a short while. The finished levelling compound remains workable for around four hours.
Before applying the levelling compound, wet any dry and water-absorbent bases.
Spreading the levelling compound
Spread the levelling compound on the base either with a levelling spray or a steel trowel. You can recover and reuse any extra compound. When applying several layers of the levelling compound, allow the previous layer to harden completely before applying the next layer. Depending on the conditions, the hardening will take one to two days. If necessary, the dried surface is ground after the application of each layer of levelling compound.
Coating
The levelled surface can be papered, tiled or painted with a cement-resistant paint. You can also float the surface with a moist sponge. Wait until the levelling compound has hardened a little before floating.
In dry conditions, wet the levelled surface with a water spray.
A levelled surface that has gotten dirty can be vacuumed, re-levelled, painted or papered in accordance with the instructions of the paint or wallpaper manufacturer.
Waste handling
Hardened product and empty, dry packages can be delivered to a landfill. A liquid product must be delivered to a hazardous waste reception point.
Material usage |
1 mm layer approx. 1.2 kg/m² |
Water requirement |
4.8-5.6 l/20 kg |
Type |
powder |
Binder |
cement |
Colour |
grey |
Maximum grain size |
0.6 mm |
Package size |
20 kg |
Storage |
storage time in a dry location approx. 1 year |
Layer thickness |
2 - 10 mm |
Lowest usage temperature |
+ 10°C |
Workability time |
4 h |
Coatability |
painting, papering and tiling |
Hardening time |
approx. 1 day at + 20°C, approx. 2 days at + 10°C drying time depends on layer thickness and the humidity in the drying area |
Compressive strength |
28 days approx. 5 MPa |
Adhesion strength |
> 0.5 MPa (for a concrete surface) |
Fire class |
A1 |
Waterproofness |
waterproof |
The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.