Socle and adjusting plaster SOL

Ask for more information

Product description

Fescon Socle and Adjusting Plaster SOL is a lime cement-based, polymer-modified fibre-reinforced plaster that contains additives improving its weather resistance and reducing capillary water absorption. The maximum grain size is 0.6 mm. 

  • Easy to use
  • Rubbable
  • Good workability characteristics
  • Good grip on the base
  • Spray-applied
  • M1 approval

Applications

  • Adjustment of concrete, brick and block surfaces both indoors and outdoors
  • Adjusting and levelling of concrete and block foundation walls
The product is listed in the portal for building products that can be used in Nordic Swan Ecolabelled buildings.
GTIN code Product name Product number Package size
6416841530066 SOCLE AND ADJUSTING PLASTER SOL 25 KG 53006 25 kg

Base

Clean the base of loose dust and dirt. Remove cement paste from concrete surfaces. Wet the dry base until it darkens. The best time to wet the surface is the previous night.

Mixing

Refer to the bag for how much water the plaster requires. Add the dry material to the water and mix with a concrete mixer for around ten minutes. With a power mixer or a drill paddle, around one to two minutes of mixing is sufficient. Allow the plaster to stand for around ten minutes and mix it again for a short while. Find the correct consistency at this stage by gradually adding the rest of the water. We do not recommend adding all of the water right at the start. The finished plaster remains workable for around two hours.

Work instructions

Spread the plaster with a plaster sprayer or a steel trowel onto a base damp enough to be darker in colour. The recommended thickness of a single plaster layer on walls is no more than 5 mm and, on foundation walls, 10 mm. The levelled walls can be coated with, for example, Fescon Facade, Silicone resin coating MC, Piirto-, Fescosan or painted with Fescon Stone Colour S. Thin-layer-plastered foundation walls can be left uncoated. Avoid plastering in high winds or in direct sunlight. The lowest working temperature is +5°C.

After treatment

In very damp conditions, keep the fresh plastered surface damp by spraying it with water or by protecting the surface with a plastic film. The need for aftercare depends on the conditions. It should continue for at least one to two days.

Storage and handling of waste
See the separate storage and disposal instructions https://www.fescon.fi/en/material-bank

Material usage

5-10 kg/m² (with a 2-5 mm layer thickness)

Water requirement 4.5-5.5 l/25 kg
Finished compound 13 - 14 l / 25 kg
Type powder
Colour gray
Maximum grain size

0.6 mm

Package size 25 kg
Storage

in a dry location approx. 1 year

Lowest usage temperature

+5°C

Workability time 2 h
Compressive strength

approx. 10 MPa

Pull-out strength > 1.5 MPa
Reaction to fire A1
Limitation of liability, product use notes and restrictions: Please familiarize yourself with Fescon Oy's general terms of delivery and the design and work instructions related to the product.