Filling plaster TLR

Ask for more information

Product description

The Fescon Filling Plaster TLR is a quickly hardening and drying filling plaster for interior wall surfaces and dry, humid and wet areas.

Applications

  • Wall and ceiling surfaces in dry, humid and wet areas
  • Suitable for straightening, conduit filling and patching of concrete, plaster, block surfaces, lightweight concrete, sand-lime bricks and burnt brick surfaces
  • The finished surface is suitable for a tiling base, and it can be waterproofed with Fescon Waterproofing Compound
  • On old paint surfaces, the Fescon Tile Adhesive Plaster is used as the adhesive plaster
  • The filling plaster cannot be used for floor levelling, soft lime cement plastering or surfaces levelled with a water-soluble compound
  • If necessary, can be overlaid with Fescon wall levellers
The product is listed in the portal for building products that can be used in Nordic Swan Ecolabelled buildings.
EAN code Product name Product number Package size
6416841201089 FILLING PLASTER TLR 20 KG 20108 20 kg
Base

The surfaces must be solid, clean and dust-free. Carefully remove weak and loose material. Before applying the plaster, use water or Fescon Primer to wet dry and water-absorbent bases.

Mixing

Refer to the package for how much water the plaster requires. Add the dry material to water and mix with a drill paddle or other suitable mixing tool for around one to two minutes. The finished plaster remains workable for around 20-30 minutes.

Spreading the filling plaster

Spread the plaster on the base either with a levelling spray or a steel trowel. If you are applying several layers of plaster, you can allow the previous layer to harden or double up using the wet on wet method. If necessary, the dried surface is ground after the application of each layer of plaster.

Spreading the levelling compound

Spread the levelling compound on the base either with a levelling spray or a steel trowel. You can recover and reuse any extra compound. When applying several layers of the levelling compound, allow the previous layer to harden completely before applying the next layer. Depending on the conditions, the hardening will take one to two days. If necessary, the dried surface is ground after the application of each layer of levelling compound.

Coating

Can be overlaid or waterproofed after around 24 hours. 

After treatment

In dry conditions, wet the levelled surface with a water spray.

Storage and handling of waste
See the separate storage and disposal instructions https://www.fescon.fi/en/material-bank

Material usage

1 mm layer approx. 1.5 kg/m²

Water requirement max. 3.8 l/25 kg
Type powder
Binder portland cement, aluminate cement, gypsum
Colour grey
Maximum grain size

1.2 mm

Package size 20 kg
Storage

storage time in a dry location approx. 1 year

Layer thickness

partial levelling 5 - 50 mm, overlaying 5 - 30 mm

Lowest usage temperature

+10°C

Workability time 20-30 min
Coatability Can be overlaid or waterproofed after around 1 day from plastering. Relative humidity of the base < 85% RH
Hardening time

approx. 1 day at +20oC, approx. 3 days at +10oC
drying time depends on layer thickness and the humidity in the drying area

Adhesion strength

> 0.5 MPa (for a concrete surface)

Waterproofness

waterproof

Emission class meets the requirements of emission class M1 for building materials