Contact us
+358 20 789 5900 or with form
Offer request 0
Tile adhesive plaster VSL
Tile adhesive plaster ILL
Tile adhesive plaster SS2
Tile adhesive plaster SSL Lite
Tile seaming plaster SML
« Back to the product group

Tile adhesive plaster VSL

Ask for more information

Product description

Fescon Tile Adhesive Plaster VSL is an M1-rated dry mortar with a cement binder. Enables tiling without strips or other spacers, see research report VTT-S-03707-10. A frost-resistant adhesive plaster, see test report VTT-S-05960-12. Suitable for indoor and outdoor use. 

  • Easy to use
  • Good workability characteristics
  • Good adhesion strength (>2 N/mm2 )
  • Meets the C2 tensile strength requirements
  • S1 flexibility class
  • Non-sag (T)
  • For floors with underfloor heating

Applications

  • Suitable for dry and humid walls and floors with concrete, tile, plastic and painted surfaces, and surfaces coated with Fescon Waterproofing Compound both indoors and outdoors, and floors with underfloor heating.
The product is listed in the portal for building products that can be used in Nordic Swan Ecolabelled buildings.
EAN code Product name Product number Package size
6416841631060 TILE ADHESIVE PLASTER VSL 63106 5 kg
6416841203021 TILE ADHESIVE PLASTER VSL 20302 20 kg
Base
  • Clean, undamaged, dust-free and level
  • If you are laying tiles on top of an old coating, you must ensure the adhesion of the old coating and roughen the base.
  • Sufficient strength and load-bearing capacity
  • Switch underfloor heating off two days before tiling
  • Temperature > +10°C
  • Loose coatings, cement paste and other impurities must be mechanically removed
Instructions for use
  • Mix a bag (20 kg) of the levelling compound in around 6.0 litres of cold water
  • mix into a consistent mass with a power mixer or a drill paddle.
  • spread the plaster on the base while pressing hard and rake it.
  • Workable for about three hours after adding water
  • Wash tools with water immediately after completing the work
  • Remove dried plaster mechanically
  • Choose the tooth size of the plastering trowel according to the size of the tile and the adhesion surface.
Grouting
  • Grout after around one day with absorbent bases with solid bases and waterproofed surfaces, grout after 2-5 days.
Other considerations
  • The information is based on tests and practical experience. We cannot affect conditions at the work site so we cannot assume responsibility for the end result affected by local conditions.

Storage and handling of waste
See the separate storage and disposal instructions https://www.fescon.fi/en/material-bank

Material usage

2-4 kg/m² depending on the base and the tile
Water requirement max. 6 l/20 kg
Binder special cement and polymer compound
Colour gray
Maximum grain size

0.6 mm
Package size 5 kg and 20 kg
Storage

1 year in a dry locatio
Usage temperature

+10°C...+25°C
Workability time approx. 3 h
Open time approx. 15 min
Groutable 1-5 days
Product description
Instructions for storage and disposal of products 499 KB

Operational safety bulletins

Safety data sheet Fescon TILE ADHESIVE PLASTER VSL en 239 KB

Etsitkö Nanten-lattiapinnoitteita?

Katso Tuotteet Ratkaisut