Nanten Acrylic Sealer 304

Kysy lisätietoa

Tuotekuvaus

Used as a topcoat in acrylic coating systems in areas subject to mechanical stress as well as exposure to various chemicals, fats, and similar substances.

Käyttökohteet

  • Topcoat for acrylic coating systems
GTIN-koodi Tuotenimi Tuotenumero Pakkauskoko
NANTEN AKRYYLI SEALER 304 180 KG 15410 180 kg

Base requirements and coating conditions

The acrylic surface to be coated must be clean and dry. The surface temperature must be at least +3°C above the dew point. Adequate ventilation must be ensured during application. Odours generated during the work can be reduced by using negative pressure ventilation.

Mixing

Pre-mix the required amount of Nanten Acrylic Sealer 304. Assess the effect of temperature on the required amount of hardener and add the hardener to the mixing container. Continue mixing for approximately two minutes.

Mixing ratio

Nanten Acrylic Hardener is used as the hardener, and the required amount depends on the working temperature.
1 dl of hardener = 64 g
+30°C 1 wt-%
+20°C 1.5 wt-%
+10°C 3 wt-%
+3°C 5 wt-%

Top coating

Thoroughly mixed Nanten Acrylic Sealer 305 is poured onto the floor in a bead and applied using a short-nap roller or a rubber squeegee. Once the topcoat has dried, a second coat may be applied if necessary.

Varastointi ja jätteen käsittely
Katso erillinen varastointi ja hävitysohje https://www.fescon.fi/materiaalipankki

Väri Colorless
Pakkauskoko 180 kg drum
Varastointi

+5°C to +25°C, shelf life up to 6 months. Must be stored in a warm location in tightly sealed original containers.

Tiheys

(+25°C): 0.99kg/l, ISO 2811

Käyttölämpötila

+3°C…+30°C

Käyttöaika Once poured onto the floor: approx. 15 minutes. Working time shortens as temperature increases.
Kuivumisaika

(+20°C) Recoatable after approx. 60 minutes. Fully loadable after approx. 2 hours.

Kovettumisaika

Recoatable after approx. 60 minutes. Fully loadable after approx. 2 hours.

Tartuntalujuus

> 2.0 MPa

Rasitusluokat BC5-MEC (by 54/BLY 12)
Ohenne Do not dilute
Levitystapa Applied with a rubber squeegee or mohair roller
Viskositeetti

(+25°C): 70-90 mPas, DIN 53018

VOC-pitoisuus

< 0 g/l

EU VOC 2004/42/EC (Cat A/j) max. 500 g/l (2010)

Vastuunrajaus, tuotteen käyttöön liittyvät huomiot ja rajoitukset: Tutustu Fescon Oy:n yleisiin toimitusehtoihin ja tuotteeseen liittyviin suunnittelu- sekä työohjeisiin.

Remember to consult the Maintenance Instructions for Coated Floors and the product Safety Data Sheet on our website at www.fescon.fi, or request a copy by calling +358 9 274 7970. Although the technical details provided in this product description are based on our best knowledge and experience, the information above should always be regarded as indicative. The user is responsible for verifying the suitability of the product for the intended application. If the instructions are not followed, the user assumes full responsibility for any resulting damage or consequences.