Base
The strength of the concrete must be suitable for the application, with as little shrinkage as possible. Spread the concrete to the correct level and compact it with a vibratory screed (or a hand-held vibrator). Be careful when compacting. The moment the plasticity of the concrete allows, float the concrete manually or mechanically. If the concrete has bled water, remove it before floating by slowly pulling over the surface with a rubber hose or trowel. You should begin the floating from quickly hardening areas, next to walls, door openings, columns and stoppers. Do not use aggregates containing calcium chloride, salt water or salt in the concrete.
Work instructions
Spread the dry-shake evenly either manually or using a suitable tool. Wait until the dry-shake has been dampened throughout by the water in the concrete (the surface has darkened). Float the surface as soon as possible using a low-RPM float machine. Float until moisture rises through the dry-shake and forms a plastic layer on top of the slab. When spreading the dry-shake manually, first apply two thirds of the dry-shake, float, and then apply the rest so that the surface becomes as even as possible. Float the second time in the same way as the first. If you are spreading the dry-shake with a machine, spread the entire amount at the same time.
Once the surface has hardened sufficiently, finish the surface with a low-RPM float machine with the blades level. Perform the final finish later using the same machine but at higher RPMs.
After treatment
When the floor surface withstands walking, spray the entire surface with Fescon Aftercare Agent using a suitable method. Saw the joints immediately when possible without cracking the concrete.
Other considerations
Wash tools with water.
Varastointi ja jätteen käsittely
Katso erillinen varastointi ja hävitysohje https://www.fescon.fi/materiaalipankki